Spam filteringedk on 2018-09-24
As most of you are aware, we've been experiencing significant spam over the past few weeks. As a result, we have decided to roll out a server-side spam filter. Unlike our current spam-mitigating techniques, this system applies to private messages and does not let the first matching line get through.
Various ethical concerns have been raised over the course of introducing this feature. They'll be addressed below. The short version, though, is that the system has various limitations built in designed to prevent operator abuse. Only a tiny bit of information can get out of the filters, and they do not have access to much information themselves, to the extent that we believe the obvious ways to abuse such a feature are impractical.
We've historically been reluctant to take steps like this, and we remain so, but we believe the disruption has reached such a level that this is necessary to allow the communities using freenode to collaborate effectively. The prior complement of anti-spam measures represents our preferred approach, and we intend to employ this only when they prove insufficient to minimize disruption.
For the technically inclined, you can view the changes here.
Could this be used to spy on users? Which filter a user matched is not reported to staff, only that one did. This limits the theoretical maximum rate of passive monitoring to one bit per message, far less than the information content of conversations.
Recipients of private messages are not included in the line that filters match on, so staff cannot use spam filters to see who is talking to whom.
Could this be used to shadowban users? No. If a filter blocks a message, its sender is either disconnected from the network or sent an error message.
Currently, the filter system is configured not to use the nick, username, or hostname for filter matching, so it can't discriminate against particular users at all.
The exact information filters "see" is as follows:
- The type of message (PRIVMSG/NOTICE)
- The target of the message, if that target is a channel. For private messages, filters can see that they are PMs but not who their target is.
- Whether or not the sender is identified (but not their account name)
- The full contents of the message
The code can be configured to filter on the
[email protected] of the sender. We
haven't enabled this, and have no current plans to, but this is subject to
change should the nature of the spam demand it.
Filtering is always performed on the server originating a message, and inside the ircd process. This system will never cause a message to be distributed more widely than before.
Staff can, as always, answer your questions about this change, and we welcome constructive feedback. Private messages to staff are not subject to filtering.